#LINUX SHOW INTERFACE ERRORS MAC#

These settings allow the user to control the hash elasticity/max parameters. if eth0 is some bridge's active port, then you can adjust /sys/вЂ¦./eth0/brport/multicast_router) Note: this setting can be enabled/disable on a per-port basis, also through sysfs interface (e.g.

The default is 1 which lets the system automatically detect the presence of routers (currently this is limited to picking up queries), and 2 means that the ports will always receive all multicast traffic. A port with a multicast router will receive all multicast traffic. This allows the user to forcibly enable/disable ports as having multicast routers attached. If the collisions have not been resolved however the system will refuse to reenable snooping. It also allows the user to reenable snooping when it has been automatically disabled due to hash collisions. This option allows the user to disable IGMP snooping completely. For brN, the settings can be found under /sys/devices/virtual/net/brN/bridge. IGMP snooping support is not yet included in bridge-utils or iproute2, but it can be easily controlled through sysfs interface. If you are running multiple or redundant bridges, then you need to enable the Spanning Tree Protocol ( STP) to handle multiple hops and avoid cyclic routes.ДЇorward delay 150.00 bridge forward delay 15.00Дesignated root 0000.000480295a00 path cost 100Дesignated bridge 001e.00048026b901 message age timer 17.84Дesignated port 80c1 forward delay timer 0.00Дesignated root 8000.00004c9f0bd2 path cost 100Дesignated bridge 8000.00004c9f0bd2 message age timer 0.00Дesignated port 8002 forward delay timer 0.00 Setting ageing time to zero makes all entries permanent. # brctl setageing //bridgename// //time//

Normally there should be no need to modify this parameter, but it can be changed with (time is in seconds). The entries in the forwarding database are periodically timed out to ensure they won't stay around forever.

#LINUX SHOW INTERFACE ERRORS MAC#

The aging time is the number of seconds a MAC address will be kept in the forwarding database after having received a packet from this MAC address. Once a bridge is running the brctl showmacs will show information about network addresses of traffic being forwarded (and the bridge itself). The brctl show command gives you a summary about the overall bridge status, and the instances running as shown below:Д«ridge name bridge id STP enabled interfaces

Linux show interface errors